How to reset IP camera of R series

This guide explains how to reset Camius IP cameras that have a reset button. The following camera models are applicable:

There are three ways to reset the IP camera to default (factory) settings:

  • by pressing a reset button
  • by loading default settings from the IP cameras’ web browser interface
  • through the Camius NVR or DVR

Option 1 – Resetting the IP camera using the camera’s reset button

If you have forgotten your IP camera’s password, you can reset it by following these steps:

  1. Locate the reset button on the camera.
  2. Remove the ‘RESET/micro SD’ cover and use a paper clip to press and hold the reset button for 10 seconds.
  3. The camera will restart, and you can then set a new password. If you reset a camera connected to the Camius NVR’s PoE port, you do not need to set a new password for the camera.
  4. The NVR will assign a unique IP address to the camera, allowing you to access and control it through the NVR only.

Camera Reset button
Picture 1 (SPOT828A-R, SPOT8R)
BoltX5R reset button sd card scaled
Picture 2 (BOLTX536R,BOLTX5R)
camius ip camera sd card reset button design
Picture 3 (IRIS5R, IRIS528R, IRIS8R))

The latest GuardVR4K, 4K dome camera, with a vandalproof housing. To access the reset button, remove the housing using a special hex key included with the camera and press the reset button (RST) for 10 seconds, as shown in picture 5. 

GuardVR4K open housing
Picture 4 (GuardV4K)
GuardVR4K open housing
Picture 4 (GuardV4K)

Option 2 – Resetting the IP Camera from the Camera’s Web Browser Interface

Another method to reset the camera to factory settings is through the Camius IP camera’s web browser interface. Follow these steps:

  • Access the IP camera’s web browser view (refer to the guide for accessing the IP camera using a web browser)
  • Click on Remote Setting (top right corner), then go to System >> Maintenance >> Load Default >>Apply.
  • After resetting the IP camera using either the reset button or the web browser interface, you will need to set a new password.

web browser new password setup 2023

Option 3 – Resetting the IP Camera from the Camius NVR

If you are viewing your cameras from a monitor connected to the NVR’s HDMI video output, follow these steps:

  • Navigate to the left bottom corner of the screen to access the NVR’s menu.<
  • Click on Setup >> System >> IP Camera Maintain >> Load Default.
  • Select the camera under the Channel column that you wish to reset to factory settings and click the Default button.

If you are accessing the NVR using a web browser, follow these steps:

  • Click on Remote Setting (top right corner), then go to System >> Maintenance >> Load Default >> Apply.

These steps will help you reset your IP camera and restore it to factory settings.

IPVAULT2256PR SYSTEM IP CAMERA LOAD DEFAULT